After a round of equipment and process improvements we can now produce rigid PVC film at a thickness of 0.05 mm, and the quality at that gauge holds up.
Thin rigid sheet matters because it lets converters laminate or composite it with other plastic films, which opens applications where a heavier gauge would simply be wasted material. Thinner sheet also saves cost per square metre, which is why the limit was worth pushing.
The difficulty is not only rolling thinner. At 0.05 mm, gauge variation, gel points and surface defects all become visible in the finished pack, so the melt, the cooling and the wind-up have to be stable at the same time.
If your specification sits close to the thin end, tell us the process it will run on. A sheet that forms well at 0.1 mm does not automatically behave the same way at 0.05 mm.
